Rough-in to final, on photographic record.
Checklists for service upgrades, remodels, and new construction. Panel-label documentation, rough-in vs final photo gates, ground-fault + AFCI placement evidence. The AHJ inspection bundle builds itself.
14 days free · no credit card · nothing to cancel
Four checklists. Service to new construction.
NEC-aligned defaults — every checklist is editable, but most crews use them out of the box.
Panel swap, on the record.
- 01Existing panel — close-up of label + capacity
- 02Meter base condition
- 03Service entrance cable + condition
+3 more shotsShow fewer
- 04Existing grounding system
- 05Bonding to gas/water
- 06New panel — fully labeled circuits
Pre-drywall photo trail.
- 11Each panel — open with all wiring visible
- 12Junction boxes — visible + accessible
- 13Cable runs — stapling + protection
+3 more shotsShow fewer
- 14Box-fill verification
- 15Ground wire continuity
- 16Box plate count + per-room layout
AFCI + GFCI placement, documented.
- 21Each GFCI receptacle (bathroom, kitchen, garage, outdoor)
- 22Each AFCI breaker labeled in panel
- 23Tamper-resistant receptacle verification (dwelling units)
+3 more shotsShow fewer
- 24Ground-fault test on every GFCI
- 25Smoke + CO detector placement
- 26Working clearances around panels
AHJ-ready bundle before the inspector arrives.
- 31Final panel — labels visible + readable
- 32Each circuit tested + functional
- 33All cover plates installed
+3 more shotsShow fewer
- 34Continuity + ground-fault tests documented
- 35Permit posted + visible
- 36Customer walkthrough
The panel directory writes itself.
Photograph each circuit as you label it. The AI matches the photo to the circuit number, the panel directory PDF generates from the photo set.
- ✓Photo + voice-note per circuit during labeling
- ✓Auto-generated panel directory PDF, branded with your shop's letterhead
- ✓Customer-facing version (room names) + electrician version (circuit numbers + amperages)
- ✓Stored with the project — pull it up six years later for a service call
Plugs into your billing + dispatch stack.
- ✓QuickBooks — photo-attached invoices for service + project work
- ✓GoHighLevel — review automation post-completion
- ✓Stripe — payment processing for service calls + change orders
- ✓Zapier — new-job and new-photo triggers into 5,000+ apps
What electrical shops actually ask.
Does it work for both new-construction and service?+
Can the apprentice photograph everything without missing a code requirement?+
What about service-call documentation for follow-up?+
Do you support EV-charger install documentation?+
What crews say in their own words.
“Every service company and construction company should have this software and integrated into their process of getting work done properly and with super communication with clients. All of our customers really like it.”
“Photos are a huge part of daily process, this absolutely take all the excuses away. No more searching for photos and we believe you can never have too many photos of a project. So yes two thumbs up!”
“Very convenient app, highly recommend”
Rough-in. Final. AHJ-ready before the inspector calls.
Start the trial on one panel-upgrade job. By the inspection date the file is already built.